6
GB/IE
The drill stand must be mounted on a
workbench or a stable, tilt-free table, to
ensure a safe work. Use the drill holes
5
in
the base plate
6
.
§ Assembly
Note: You need a 5 mm hexagon key (provided),
two open-ended spanners (10 mm & 14 mm) and
a slot screwdriver (1.2 x 8.0 mm) for assembly and
adjustment.
Connect the pillar
7
to the base plate
6
.
Then fix the slider
9
on the pillar (see Fig. A).
Mount the lever arm
2
onto the slider
(see Fig. B). Tighten the screws and nuts as
tight as possible.
Mount the vice
13
onto the base plate. To do
this connect the screws with the guide slots
4
in the base plate through the two long slots
14
(see Fig. C).
Note: The vice can be positioned exactly by
moving the guide slots and long slots.
§ Mounting the work-piece
Hold the quick-release button
16
pressed and
pull the locking device
15
back as far as it
goes (see Fig. D).
Place the work-piece into the vice
13
.
Press the quick-release button and push the
locking device with the clamping jaw
17
against the work-piece.
Fix the work-piece with a right turn (see Fig. E).
§ Clamping in and
adjusting the drill
Fit the drill with its clamping collar into the
drill holding fixture
3
and tighten securely
(see Fig. F).
Insert a suitable drill bit into the chuck.
Unscrew bolt
12
(see Fig. G).
Move the slider
9
with the clamped in drill
on the pillar
7
, until the drill nearly touches
the work-piece.
Retighten screw securely.
§ Adjusting the drill depth
Loosen the block
8
and slide it up to the
slider
9
(see Fig. H).
Loosen the locking screw
10
by turning it to
the left (see Fig. H).
Make sure that the bolt
1
will be released
doing this and slides down to the lowest
position.
Move the lever arm
2
down and read off
the desired drill depth on the drill gauge with
indicator
11
.
Fix the locking screw
10
and block
8
with a
right turn (see Fig. I).
§ Adjusting the work piece
Loosen the fixing screws of the vice
13
.
Adjust the vice with the work piece by sliding
it into position.
Mark the exact position and punch a drilling
point on the work-piece. Retighten the vice
(see Fig. J).
§ Storage and care
Store the hexagon key in the fixture on the
slider.
Store the product in a dry place, out of the
reach of children.
Clean the product with a damp cloth.
Lightly grease the moving parts, rub the plain
metal parts with an oily cloth to protect them
from rust.
§ Disposal
The packaging is made from
environmentally friendly materials,
which may be disposed through your
local recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
100714_14_DK_02.indb 6 29/4/14 5:43 am
(25 strony)
(40 strony)
(61 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji